The Concept of Hardness of Water
and oceans. Water is said to be hard if it contains some specific type
of dissolved minerals. It is important to note that not all dissolved
salts make water hard.
being piped to your home. The treatment removes only the insoluble
particles and kills bacteria. So the water still is not pure. It
contains natural compounds dissolved from rocks and soil. It may also
contain traces of chemicals dumped from homes, farms and factories.
dolomite or gypsum, contains dissolved calcium and magnesium sulphates
and hydrogen carbonates. These salts make the water hard.
Hard water does not form lather easily. Instead, it forms a precipitate
or scum. It requires much soap to react with all the dissolved minerals
before enough lather is formed. Therefore, hard water wastes soap during
acids. Soaps are made from animal fats by treatment with alkali (NaOH
or KOH). Ordinary washing soap is a compound of stearic acid, C17H35COOH. The nature of such soaps is the salt, sodium stearate, C17H35COONa+. Sodium stearate is soluble in water but calcium stearate is not.
hard water react with soap and precipitates as scum. The nature of scum
is either calcium stearate or magnesium stearate:
will not form any lather with water until all the calcium and magnesium
ions have been precipitated. Hard water, therefore, wastes soap. This
means that more soap may be used for an efficient washing. The amount of
soap needed to just produce froth can be used to estimate the hardness
problem of scum formation only occurs with soaps. Soapless detergents
do not produce scum. The trade names for some soapy detergents sold in
Tanzania include Komoa, Kuku, Taifa, Mbuni, Mshindi, Changu, Jamaa and several other bar soaps. The trade names for some soapless detergents include Omo, Foma, Tesa, Toss, Dynamo, Swan, etc.
is generally said to be hard if it contains soluble salts of calcium
and magnesium. The salts are calcium and magnesium sulphates and
hydrogencarbonates. Hardness of water is caused by higher than usual
levels of calcium (Ca2+) and magnesium (Mg2+) ions in water.
this solution passes over and through rocks containing chalk, limestone
or dolomite, the rainwater very slowly dissolves them:
which can dissolve to a limited extent in water. The presence of these
dissolved substances also causes the water to be hard. These substances
dissolve sparingly in water to form Ca2+ and Mg2+ ions which are responsible for water hardness as stated early.
Test tube rack-
Five clean test tubes
Measuring cylinder (100cm3)
Calcium sulphate solution (1 mol dm-3)
Magnesium sulphate solution (1 mol dm-3)
Sodium sulphate solution (1 mol dm-3)
Potassium sulphate solution (1 mol dm-3)
Label five clean and dry test tubes as A, B, C, D and E. 2
Add 10 cm3 of 1.0M calcium, magnesium, sodium and potassium sulphate solutions and distilled water in each of the test tubes respectively.
Add 5 cm3 of soap in each test tube
Shake the test tubes well and place them in a test tube rack
Observe the amount of lather formed in each test tube, and if there is any precipitate (scum) formed.
|Test tube||Salt present||Ions present in solution of salt||Lather or scum formed?||Water hard or soft?|
|A||calcium sulphate||Ca2+, SO42-||scum is formed||Hard|
|B||magnesium sulphate||Mg2+ , SO42-||scum is formed||hard|
|C||sodium sulphate||Na+, SO42-||lather is formed||soft|
|D||potassium sulphate||K+, SO42-||lather is formed||soft|
|E||distilled water||no ions||lather is formed||soft|
the result of experiment, we can conclude that scum is produced when
either calcium or magnesium salt is present in water. So, high levels of
calcium or magnesium ions in water are responsible for water hardness.
of the problem it causes, hard water is often softened for use in
factories, industries and homes. That means removing the dissolved
calcium and magnesium ions. Described below are the methods of treating
and purifying hard water.
removes temporary hardness in water, as you saw early. Boiling causes
calcium carbonate to precipitate. The hydrogencarbonate in water are
decomposed to carbonates, which are insoluble in water
this way, the calcium is removed, since the calcium carbonates being
insoluble, takes no further part in the reaction. An insoluble calcium
salt cannot cause hardness. However, this method uses a lot of fuel,
which makes it expensive to do on a large scale.
removes all impurities from water. This gets rid of both temporary and
permanent hardness. In distillation, the water is boiled and the steam
collected, cooled and condensed. Distilled water is pure and softest
water. All the dissolved substances have been removed. Like boiling, it
is an expensive option in terms of fuel used. But it is essential for
some purposes, for example for laboratory experiments and for making
of calculated amounts of calcium hydroxide can remove temporary
hardness. The quantity to be added should be properly calculated because
excess would cause hardness on its own account. The amount of calcium
hydroxide to be added is calculated based on knowledge of the hardness
of water and the capacity of the reservoir (Clark’s method). The calcium
hydroxide reacts with the hydrogencarbonates dissolved in water and
precipitates as the insoluble calcium carbonates.
soda removes both temporary and permanent hardness by precipitating
calcium carbonate. It reacts with calcium hydrogencarbonate (which
causes temporary hardness) to form sodium hydrogencarbonate like this:
sodium salts are soluble, but do not cause the water to be hard. The
calcium and magnesium ions are precipitated as insoluble calcium and
magnesium carbonates. Ionically, the situation is like this:
is a container full of small beads. These beads are made of special
plastic called ion exchange resin. The resin beads are porous and
contain sodium ions. When hard water flows through the resin, the
calcium and magnesium ions in the water are exchanged for the sodium
ions and attach themselves to the resin. This process, therefore,
removes calcium and magnesium ions from the water. They are replaced by
sodium ions, which do not make the water hard.
all sodium ions have been removed from the resin, it is regenerated by
pouring a concentrated solution of sodium chloride through it. The
sodium ions remove the calcium and/or magnesium ions off the resin and
the ion exchanger is ready for the use again.Other ions could also be
used instead of sodium for the resin. But sodium chloride is normally
used to supply the sodium ions because salt is cheap.
modern washing powders now have softeners added to them. The softeners
are often phosphates. The phosphates ions react with calcium ions to
form calcium phosphate and remove the hardness.3Ca2+(aq)+ 2PO43-(aq)→ Ca3(PO4)2(s)
significance of water in daily life is well known to everyone. The
water we obtain from natural sources is never pure. It contains
dissolved minerals which render the water unfit for direct uses. The
water from some sources contains calcium and magnesium compounds
dissolved in it. These compounds are responsible for water hardness. To
make the water fit for various uses, it is imperative to remove the
hardness. The following points state why it is important to treat and
purify hard water:
water wastes soap. To get enough lather with hard water, it requires
more soap than it does with soft water. So it is important to soften the
water in order to save the soap and hence reduce the cost of washing.
Laundry uses less soap and can be done at lower temperatures.
and purifying hard water eliminates the possibility of forming
limescale deposits in water boilers, kettles, washing machines, water
heaters, shower heads and dish washers. The scale formed around the
heating elements can cause the element to overheat and fail.
and purified water leaves no scum on clothes during washing. Scum
spoils the finishing of some fabrics. It forms nasty deposits (marks) on
clothing that has been washed.
water has the advantage of not blocking the water pipes. In industry,
deposits of scales can block the pipes in boilers. This is a safety
hazard as it could cause pressure to build up until there is an
explosion. A similar coating can occur in hot water pipes at home and in
central heating systems.
dissolved calcium and magnesium salts improve the taste of water.
Distilled water is tasteless and quite unpleasant to drink. This is why
water-processing plants add some salts in the distilled water to make it
- Calcium dissolved in hard water is an essential
mineral for growth of bones and teeth. It makes our teeth and bones
hard, strong and resistant to shear and pressure.
- In some
places, old lead pipes are used for water supply. Lead is very
poisonous, and a little of it can dissolve in soft water. But the
carbonate (CO32-) or sulphate (SO42-)
ions present in hard water reacts with lead to form a coating of lead
carbonate or lead sulphate that prevents lead from dissolving. This
prevents lead poisoning.
- A coating of calcium carbonate inside pipes, boilers and radiators helps to prevent corrosion.
recent years, it has been suggested that drinking hard water helps to
prevent heart diseases. 6. It has also been found that hard water is
good for brewing beer.